'); doc.close(); }
4510 Nitro Sport Pro.15
Traxxas Nitro Sport RTR 1/10 scale Stadium Truck

  (Click on Image to enlarge)

List Price:

(You can always remove this item later)

This is the Traxxas Nitro Sport Ready-to-Run 1/10 scale Stadium Race Truck
with TQ Traxxas Pistol Grip Radio and On-Board Push Button EZ Start System,
TRX Pro.15 Engine and Pre-painted Body (see listing below).
This kit is based on the Nitro Rustler.

****As of 6/05/06 the Nitro Sport has the following new features;****
New Six Color Body Graphics
EZ-Start Controller with Electronic Diagnostics
Rubber Sealed Bearings
Chrome TRX Pro-Star Wheels with Pre-Glued Tires
Updated Owner's Manual
Grey Ultra Shocks with White Powder-Coated Springs
High-Torque Steering Servo

Pre-Painted Bodies:
TRAC50A2-Red and Silver
TRAC50A4-Black and Silver
TRAC50A6-Blue and Silver

FEATURES: (RTR) Ready To Run with radio system installed
T-6 flat aluminum chassis rear and black fiber composite front
Countersunk holes under the chassis
Fiber composite upper plate/front brace
4 composite oil-filled Ultra shocks with white powder coated springs
4-wheel independent suspension
Telescoping U-joint drive shafts
281 Magnum, 6 (5x11mm) ball bearing transmission with adjustable
slipper clutch and planetary gear differential with steel internal
75cc fuel tank with flip-top lid and primer bulb
Adjustable turnbuckle tie-rods
Composite black tuned pipe with pressure fitting
Disc brake (composite)
Fiberglass front hinge pin brace (tie bar)
Chrome TRX Pro-Star 2.2" wheels
Single point steering
Black colored composite parts
Front and rear bumpers
Pre-installed servo saver on servo
Black composite cover for the receiver and receiver battery box
Servo reversing and trim on radio
Air filter (one stage, bell shaped)
Ballon type receiver cover
Pressurized 2.5 ounce (75cc) fuel tank with rubber mount cushions
Pre-painted polycarbonate body with rear spoiler
Push button EZ start system with electronic diagnostics,
powered by a standard 6-cell battery that heats glow plug and
starts the engine with an on-board motor.
2-shoe clutch system
TRX Pro.15 engine w/ round alum heatsink (non-anodized) head
foam bell type air filter, ball bearings, short crankshaft,
ABC construction, easy adjust two needle carburetor,
on-board electric motor start system and glow starter,
starter, tuned pipe, glow plug, metal throttle arm,
aluminum piston with oil groove, channeled beam conecting rod
TQ pistol grip 2-channel radio system with servo reversing,
trim adjustments, receiver battery box, switch harness,
70/30 or 50/50 throttle neutral, standard throttle servo and high-
torque steering servo,red light power indicator (low when flashing)

SPECS: Length: 17.27" (439mm)
Front track: 12-1/2" (318mm)
Rear track: 12-3/8" (314mm)
Weight: 62 ounces (without radio)
Height: 6" (152mm)
Wheelbase: 11.313" (287mm)
Wheel diameter: 2.2"
Fuel capacity: 2.5 ounces (75cc)
Engine: TRX Pro.15
Gear ratio: Adjustable 8.43:1 to 12.64:1
Differential: Planetary gear type (not ball)
Brake: Disc
Chassis: Double-decked (aluminum and composite)
Spur gear: 70 black nylon tooth (32 pitch)
Clutch bell: 20 tooth black steel (32 pitch)
Castor block front 30 degrees .

INCLUDES: One TQ pistol grip radio
One Nitro Sport assembled with TRX-Pro .15 and glow plug
One Pre-Painted Body and Spoiler
One Decals
One EZ start module
One Black plastic shock collars and pistons
One Antenna tube and cap
Six 5x11mm ball bearings in transmission
Eight 5x11mm metal bushings for wheels
Two 5x10mm bearings for clutch
One Extra receiver cover balloon
One Instructions
One Window mask sheet
One Tool bag (4-way wrench, open end wrench and 2 allen wrenches)

REQUIRES: 12 "AA" batteries
One 6-cell battery (for EZ-Start system) and charger

COMMENTS: For ball bearings use:
8- 5x11mm for wheels (DTXC1549 10 pack)
6- 5x11mm for transmission
2- 5x10mm for clutch (DTXC1535 2 pack)
Optional ball differential TRAC4420 and slipper clutch TRAC9615
Traxxas engines run much hotter than "normal" engines (O.S., ASP,
Thundertigre, etc.). Therefore, Traxxas recommends
their Top Fuel (TRAP5010) and their glow plug (TRAG3230)
to run the engine cooler.

To convert the EZ-Starting system to a standard "pull-starter",
purchase TRAG4070 take out the three bolts on the EZ-Starter,
and install recoil starter.